Speedlink 4IN1 LEATHER POWER FEEDBACK WHEEL Instrucciones De Manejo página 16

Programming function:
DE
Remapping a button function to another button
GB
• Press both Select +  at the same time. All LEDs will flash. Programming mode is
now active.
• Press the button whose function you want to remap to another button. Either four
FR
LEDs for the pedals or two LEDs for the control paddles will now start to flash.
• Press the button which you want to remap the function to. All LEDs will flash
ES
continuously. Repeat steps 2 and 3 for remaining buttons.
• To exit programming mode, press Select +  again or wait six seconds, after
IT
which the steering wheel will automatically exit programming mode.
PlayStation2
The right and left control paddles are set to R2 and L2 as factory default. Pedals are
set to gas and brake and have the same functions as the buttons X and .
The control paddles and pedals can be remapped to the following buttons: , X, , ,
L1, L2, R1, R2, L3 (ç), R3 (è) and RY axis (ê).
Some games use the right analogue stick for gas and brake as standard. To transfer
the pedal function to the right analogue stick press START + left directional button +
gas pedal, followed by START + left directional button + brake pedal. This function
is only supported in analogue mode. The setting is deleted if the steering wheel is
switched to digital mode or if the games console is switched off.
Xbox
The right and left control paddles are set to A and X as factory default. The pedals are
set to Right Trigger and Left Trigger.
The control paddles and pedals can be remapped to the following buttons: A, B, X, Y,
White, Black, Left Trigger, Right Trigger, LT (ç), RT (è), RY axis (ê).
GameCube
The right and left control paddles are set to X and Y as factory default. The pedals are
set to A and B.
The control paddles and pedals can be remapped to the following buttons: A, B, X, Y,
Z, Left Trigger, Right Trigger, Z (ç),Start (è) and RY axis (ê).
PC
The right and left control paddles are set to Keys 1 and 2 as factory default. The pedals
are set to Y axis up and down.
The control paddles and pedals can be remapped to the following keys: 1, 2, 3, 4, 5, 6,
7, 8, 11 (ç), 12 (è), Y axis.
Resetting default button functions
Either press Start +  +  for three seconds, or unplug the steering wheel from the
games console, or turn the games console off.
1