Würth 1952 003 870 Traducción Del Manual De Instrucciones De Servicio Original página 9

DE
GB
INTRODUCTION
FR
It is compulsory to read this instruction manual before starting any
kind of action.
NL
The proper operation and full compliance of this product's
performance is guaranteed only if all the instructions provided in this
ES
manual are closely adhered to.
We guarantee that this product complies with the technical
IT
specifications described in this manual.
The manufacturer shall not be held responsible for any improper
uses other than those described herein.
PT
Use protective work gloves, protective footwear, hard hat and safety
goggles.
PL
Misuse:
DA
- This product should only be used as described in this
documentation; any other use is considered improper.
EL
- The manufacturer accepts no responsibility for any
damage caused by the incorrect or unreasonable use of
the equipment.
- Moreover, misuse shall also void the warranty.
Take care of your tools:
- Be sure to store your tools in a clean state.
- Place the tools inside their original package.
Set of special tools suitable for the repalcement of inner
ball bearings
APPLICATION
This set allows to extract easily and quickly the inner ring of the
bearings without damages (fig. 1).
Usually extracting the hubs, the rings remain in their seats and
without a special tool is not possible to remove them.
This set can be use for the replacement of the rings from Ø 40 to
Ø 61 mm.
Critical areas to catch the hold the ring (fig 3. rif.
)
B
METHOD OF PREPARATION
1
2
3
,
A
A
B
9