Maxon T-500 Manual De Instrucciones página 13

Before drilling holes in the pickup bed, ensure there are no obstructions or
items that could be damaged.
5. Hold RH mounting bracket against cor-
ner post of the pickup bed (FIG. 13-1).
Then, use 2 of the 4 bracket holes that
are not obstructed, to drill 2 holes for
(FIG. 13-1). Repeat for LH mounting
bracket.
6.
of pickup bed as shown in FIG. 13-1.
Repeat for LH mounting bracket.
7. Unlatch and unfold platform. Refer
to C2 Operation Manual if needed.
Then, adjust liftgate position so plat-
form is level from front to back.
8. Securely tighten 3 bolts fastening
RH mounting bracket to main frame
bracket (FIG. 13-1). Ensure the split
lock washers are not in the slotted
holes on main frame bracket. Repeat
for LH mounting bracket.
LIFT CORPORATION Sht. 13 of 52 DSG#
INSTALLING LIFTGATE - Continued
CAUTION
M-14-28
3/8"-16 HEX BOLT
(2 PLACES)
TEMPLATE HOLES
TO DRILL 2 HOLES
IN PICKUP BED
3/8" FLAT WASHER
(2 PLACES)
3/8" LOCK WASHER
(2 PLACES)
3/8" HEX NUT
(2 PLACES)
BOLTING RH MOUNTING BRACKET
TO PICKUP BED (LIFTGATE NOT SHOWN)
Rev. D Date: 08/13/19
CORNER
POST
FLOOR OF
PICKUP BED
FIG. 13-1