Resetting Data In The Memory; Standby - ADVANSEA MULTI S400 Manual Del Usuario

2.4.9. Resetting data in the memory

At any time, the memory of the Multi display can be returned to factory settings. To do so, a
memory reset command is accessible in the menu. The following parameters are restored in the
memory:
Speed unit:
Depth unit:
Distance unit:
Temperature unit:
Speed damping:
Speed calibration coeff.:
Temp. calibration coeff.:
Keel offset:
Depth alarms:
Speed alarms:
Temperature alarms:
Battery alarm:
Countdown timer init.:
Trip log:
Total log:
Simulation mode:
Backlighting level:
menu
Press for 2 seconds, then
displayed, then activate (on) or deactivate (OFF) the reset using
the and
Press to exit setup mode, or time out after 10 seconds.

2.5. Standby

To save energy on board, the "MULTI" display can be placed on standby by pressing for 5
seconds on the
Standby mode switches off backlighting, the screen, stops sensor measurement and processing
of NMEA input and output interfaces. Only the vital bus management and keyboard functions
remain active. Active displays present on the bus indicate measurement impossible with an OFF
icon instead of the data.
Standby mode is not saved. At any time, simply pressing one of the four keys or cutting
off the power stops standby mode and returns all device functions to normal.
menu
keys.
key.
Installation and Operation Manual S400 series
Knots
Metres
Nautical Miles
°Celsius
10 seconds
Slope at 1.0
Offset to 0
0
deactivated, high and low threshold at 0
deactivated, high and low threshold at 0
deactivated, high and low threshold at 0
deactivated, low threshold at 0
10 minutes
0
0
deactivated
0 (OFF)
until the "rESEt" page is
16