BLACK&DECKER FIRE STORM FS110L Manual De Instrucciones página 13

Fig. 24
A
B
Fig. 26
ADJUSTING TENSION OF CUTTINGHEAD RETURN SPRING
CUTTING HEAD MUST RETURN QUICKLY TO THE UP POSITION. DISCONNECT MACHINE
FROM POWER SOURCE.
The tension of the cuttinghead return spring was adjusted at the factory so that the cuttinghead returns to the "up"
position after a cut has been made. If it becomes necessary to adjust the spring tension:
Loosen the locknut (A) Fig. 27 and turn the screw (B) clockwise to increase, or counterclockwise to decrease the
spring tension. After adjustment, tighten the locknut (A).
ADJUSTING SLIDING FIT BETWEEN
CUTTINGHEAD ARM AND TRUNNION
After a long period of time, an adjustment of the sliding fit
between the cuttinghead arm (B) Fig. 27A, and the
trunnion (C) may be necessary. To adjust, turn the nut (D).
This adjustment should not be so tight that it restricts the
sliding movement of the cuttinghead arm (B) or so loose
that it affects the accuracy of the saw cut.
A
B
Fig. 25
B
A
Fig. 27
C
Fig. 27A
13
C
A
B
D