Steelcase Answer Manual Del Usuario página 23

®
Boundary Screens
Single-Connect Spanning
Installation
1.
Place boundary screen on a clean,
scratch resistant surface.
2.
Install one (1) Answer attachment
clip with four (4) flat head wood
screws (provided) (2a).
Install large wing bracket with twenty (20)
flat head wood screws (provided) (2b).
3.
Place fence End-Of-Run (EOR) vertical
junction over Answer attachment clip and
slide up into position.
TIP: If desired, you can add a screw
(provided) into the Answer attachment clip
to further secure the boundary screen to
the fence EOR vertical junction.
4.
Place three (3) washers inside pocket
of fence EOR vertical junction and install
four (4) 1/4-20 x 1/2" truss head machine
screws (as shown).
5.
Install two (2) decorative covers as shown.
6.
Install two (2) glides as shown.
7.
Lift spanning boundary screen fence
assembly up and assemble rest of assembly
as shown on page 4.
8.
Add two (2) flat head wood screws.
9.
Add support brackets to the Answer
structure, see page 19.
2a
SEE TIP
1/4-20 x 1/2" TRUSS HEAD
6
FENCE EOR
VERTICAL
JUNCTION
VERTICAL JUNCTION
5
ANSWER
ATTACHMENT CLIP
MACHINE SCREW
WASHER
4
FENCE EOR
3
DECORATIVE
COVER
LARGE WING
BRACKET
2b
8
Page 23 of 28
P/N 1115992001
Doc # 90255 Rev D