Harbor Breeze CHESHIRE II Manual Del Usuario página 10

FINAL INSTALLATION
2. Partially insert three blade screws (BB), along with
three blade washers (DD), to attach one blade arm
(G) to a blade (H). Then, tighten each blade screw
(BB), starting with the one in the middle (Fig. 2)
Repeat with remaining blades (H).
3. Locate motor screws (AA) and lock washers (CC)
that were removed in Step 4 on page 7.
Insert one motor screw (AA), along with lock a
washer (CC), through one blade arm (G) to attach
blade arm (G) to motor. Partially tighten motor screw
(AA). Now, insert another motor screw (AA), along
with lock washer (CC), to secure blade arm (G).
Tighten both motor screws (AA) securely. (Fig. 3)
Note: For easy access to motor screws (AA), turn
motor so that the flat part of the switch housing plate
aligns with the two motor screw (AA) holes on blade
arm (G).
Repeat Step 3 with remaining blade arms (G),
making sure to completely secure each blade arm
(G) before proceeding with the next.
4. If you wish to USE the light kit, remove three
screws from switch housing plate on underside of
motor. Locate BLUE and WHITE wires in switch
housing plate labeled "FOR LIGHT" and remove
cardboard label and plastic from these two wires.
Connect WHITE wire from light kit fitter (E) to WHITE
wire from switch housing plate. Connect BLACK wire
from light kit fitter (E) to BLUE wire from switch
housing plate. Make sure that molex connections are
secure. (Fig. 4) Continue with Step 5.
If you do NOT wish to use the light kit, please go
to section entitled "Using Fan Without Light Kit" on
page 12.
BB
DD
G
Hardware Used
3/16 Blade Screw
BB
DD
Blade Washer
Switch
Housing
CC
Plate
AA
Hardware Used
Motor Screw
AA
CC
5.4 M/M Lock Washer
Switch
Housing
Plate
Molex
Connections
10
Fig. 2
H
x 15
x 15
Fig. 3
A
G
H
x 10
x 10
Fig. 4
A
E