Using Fan Without Light Kit (Optional); Fan Operation - Harbor Breeze CHESHIRE II Manual Del Usuario

FINAL INSTALLATION
8. The pull chain extensions (J) supplied in one
of the hardware packs or custom pull chain
extensions (not included) may be attached to fan
and light pull chains. (Fig. 8)

USING FAN WITHOUT LIGHT KIT (OPTIONAL)

1. If you do NOT wish to use the light kit, remove
three screws from switch housing plate. (Fig. 1)
2. Align holes in extra switch housing (C) with holes
on outer edge of switch housing plate. (Note: The
wide gap in the top edge of the extra switch housing
(C) should align with the reverse switch on the switch
housing plate for the proper fit.) Re-insert screws that
were just removed. Use a Phillips screwdriver to
secure all screws. (Fig. 2)
3. The pull chain extension (J) supplied in one of the
hardware packs or custom pull chain extension (not
included) may be attached to fan. (Fig. 3)

FAN OPERATION

1. The pull chain on the switch housing plate has four
positions to control fan speed. One pull is HIGH, two is
MEDIUM, three is LOW and four turns the fan OFF.
(Fig. 1)
(For Fan)
Switch
Housing
Plate
Switch
Housing
Plate
12
Fig. 9
J
J
(For Light)
Fig. 1
Fig. 2
C
Fig. 3
J
Fig. 1