Troubleshooting - Harbor Breeze CHESHIRE II Manual Del Usuario

TROUBLESHOOTING

WARNING: Before beginning work, shut off the power supply to avoid electrical shock.
Problem
Fan does not move.
Noisy operation.
Excessive wobbling.
Fan operates but lights
fail (if applicable).
Note: A small amount of "wobble" is normal and should not be considered a defect.
Possible Cause
1. Reverse switch not engaged.
2. Power is off or fuse is blown.
3. Faulty wire connection.
1. Blades (H) are loose.
2. Cracked blade (H).
3. Full range dimmer switch.
4. Fan is new.
5. Motor housing (A) is loose.
1. Blades (H) are loose.
2. Blade arms (G) incorrectly
attached.
3. Unbalanced blades (H).
4. Fan not securely mounted.
1. Bulb(s) not installed correctly.
2. Wires in outlet box not wired
properly.
3. Wall switch to fan is off.
4. Wires light kit fitter (E) not
wired correctly.
Corrective Action
1. Push switch firmly either left or
right.
2. Turn power on or check fuse.
3. Turn power off. Loosen motor
housing (A) and check all
connections.
1. Tighten all blade screws (BB).
2. Replace blade (H).
3. Replace with an approved
speed control device.
4. Allow fan a "break in" period of a
few days, especially when running
the fan at Medium and High
speeds.
5. Turn power off. Carefully loosen
motor housing (A) and verify that
mounting bracket (B) is secure
according to instructions on page
9.
1. Tighten all blade screws (BB).
2. Re-install blade arms (G).
3. Switch one blade (H) with a
blade (H) from the opposite side.
4. Turn power off. Carefully loosen
motor housing (A) and verify that
mounting bracket (B) is secure.
1. Re-install bulb(s).
2. Check wires in outlet box and, if
necessary, re-wire according to
instructions on pages 8 and 9.
3. Make sure that wall switch to fan
is on.
4. Check wires in light kit fitter (E)
and, if necessary, re-wire
according to instructions on page
10.
14