Forch 6000 0210 Manual De Instrucciones página 29

■ Check the functioning of the spray unit each time before startup, paying special at-
tention to the hose connection and the screw connectors. Check material for cracks,
brittleness and corrosion.
■
Do not expose the filled tank to strong sunshine for any long period of time.
■
Operating temperatures must not exceed + 40 °C. Protect unit against frost.
■ Clean tank thoroughly immediately after use and then dry completely.
■
Spraying agents that are environmentally harmful should be use up as far as
possible on the object of the spraying, any unavoidable residues should be put in
a suitable holding container and sent for special disposal. Observe all laws and
regulations concerning materials hazardous to waters when temporarily storing
and disposing of such materials.
■
Keep away spraying devices and agents from children, animals and waters.
■
Do not try to clear blocked nozzles by blowing them out with your mouth.
■ The unit is not intended to store liquids, it must be emptied out after each time it has
been used and washed out thoroughly.
■
Always check the the safety / pressure relief valve (A) when pumping up the unit and do
not exceed the maximum permissible pressure of 3 bar.
■ All parts that are under pressure or conduct the liquid or operating parts and the the
safety / pressure relief valve must be checked regularly to ensure that they are in perfect
condition and function properly. Stop using the unit at once if any damage is suspected.
■
Do not allow it to remain pressurised for an extended period.
■
As a precautionary measure, we recommend that the pump spray unit be subjected to
a particularly thorough inspection every two years, preferably by the manufacturer.
Repairs to the tank are not permitted.
■
Observe the accident prevention regulation "DGUV Regeln 100-500; Betreiben von
Arbeitsmitteln [DG-UV Rule 100-500; operating work equipment]".
■ Repairs to the equipment should only be carried out by Service Stations. Order
spare parts from your authorised dealer. If the required parts are not in stock, he
will procure them for you as quickly as possible.
ATTENTION!
We hereby explicitly state that we have no liability whatsoever under the German Product
Liability Law for any damage caused as a result of unauthorised repairs or by the use of
replacement parts that were not original spare parts, and where the repair work was not
done by our after-sales service section or an authorised technician. This also applies to
accessory parts.