Headset Controls - Plantronics B230-M Guia De Inicio Rapido

Headset controls

1 2
auto caLL aNsWer: automatically answer a mobile or softphone call by putting on the
headset. You do not have to press the call button. See Smart Sensor Features.
1 Volume/Mute button
Increase/decrease volume Tap + or – button per level change
1-second press of both + and – buttons
Mute mic during a call
1-second press of both + and – buttons
Pause/Play streaming audio
2 call button
Take a call or end it
1 tap
Call back last call 2 taps
2-second press until tone heard
Initiate phone's voice-dialing
1 tap
Reconnect lost connection
3 Micro usB charging port 90 minutes for full charge
4 Power button
2-second press
On or off
1 tap
Talk time voice alert
With headset off press until LED flashes red/blue
Activate pairing mode
5 Led
Solid red. When fully charged, LED is off.
Charging
Low = 2 red flashes, Recharge = 3 red flashes
Battery status
Flashes red/blue
Pairing mode
3 4 5
smart sensor Features
auto answer call:
When you are not wearing
your headset.
auto Pause Media:
When you are listening to
streaming audio.
auto transfer call:
Whether you are wearing your
headset or not.
auto Lock call Button:
When you are not wearing
your headset
Note These features are enabled by default and can be disabled in the
Plantronics Control Panel: Devices>Device Settings>Headset Tab. Changes to the
device settings requires that you are connected and within range of the USB
adapter. The Plantronics software must be downloaded to access the Control
Panel. Refer to Step 1 Set up your headset and computer.
When you have an incoming call on
your mobile or softphone, put on the
headset and the call will be answered
automatically. You do not have to
press the call button.
When you are streaming audio from
your mobile phone or PC. Remove
the headset and the streaming audio
pauses. Place your headset back on
and the audio resumes.
Note If the media player has been
playing less than 10 seconds you will have
to manually restart the media player.
If you are not wearing your headset
and there is an incoming call on
your mobile phone, the audio will be
routed to the mobile phone. When
you put the headset on, the audio will
be automatically transferred to the
headset and will auto answer.
If you are already wearing your
headset and there is an incoming call,
the audio will be routed to the headset
and you will need to press the call
button to answer the call.
Prevents accidental dialing from your
mobile phone when the headset is not
worn.