Fully Programmed Bending - Greenlee 855GX IntelliBENDER Manual De Instrucciones

Operation (cont'd)

Fully Programmed Bending

The computer can also be used to help lay out bends.
1. Press the button next to "PROG BEND" to start
programming a bend.
SELECT ANGLE
OR FUNCTION
Note: Press the home button
return to the home screen shown above.
2. Press the button next to the type of conduit dis-
played in the LCD display that you will be using; or
press the button next to "LOAD FILE" to retrieve a
saved bend from a USB thumb drive. (See page 16)
Press NEXT to proceed or BACK to return to the
previous screen.
Refer to the "Load File from USB" section after
"Fully Programmed Bending" for instructions on
loading saved bends.
Greenlee Tools, Inc.
3. Press the button next to the size of conduit dis-
at any time to
4. Press the button next to the type of bend that you
5. Press NEXT to proceed or BACK to return to the
13
855GX Electric Bender
played in the LCD display that you will be using.
Press NEXT to proceed or BACK to return to the
previous screen.
Note: "1/2" and "3/4" are displayed only when
"PVC RIG" conduit type is selected in step 2.
are going to make.
a. Select "STUB/KICK" for stubs or kicks.
b. Selecting "OFFSET" and NEXT will display
a new window from which you can choose
whether you want the length to be from the end
of the conduit to the start of the first bend or to
the end of the second bend.
c. Selecting "SADDLE" and NEXT will display
a new window from which you can choose a
three-bend or four-bend saddle.
d. Select "U-BEND" for back-to-back 90° U-bends.
previous screen.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070