Fan Assembly. Pgs - stori Epilogue Guia De Instalacion

5. Fan Assembly.
If you wish to extend the hanging length of your fan,
you must remove the hanging ball from the downrod
provided to use with an extended downrod (sold
separately). [If you wish to use the downrod provided,
please proceed to instructions following the dotted line
below.]
To remove hanging ball, loosen set screw on hanging
ball, lower hanging ball and remove stop pin. Slide
hanging ball off the original downrod, A, and slide it
down the longer downrod, B (the top of the downrod
should be noted as having a set screw hole; use this
hole when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging ball. Be
sure stop pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely.
WARNING: Failure to tighten set screw (on hanging
ball) completely could result in the fan becoming loose
and possibly falling.
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the downrod.
Loosen yoke set screws and nut at top of motor
housing. Remove pin and clip from motor housing
yoke.
Locate canopy cover in one of the hardware packs.
Slide downrod through canopy, canopy cover and yoke
cover. (Note: Canopy cover must be turned with shiny
side toward motor housing.)
Thread electrical wires and safety cable through
downrod and pull extra wire slack from the upper end
of the downrod.
Place downrod into the motor housing yoke and
re-insert pin and clip that were previously removed.
Tighten yoke set screws and nut securely. Lower yoke
cover to motor housing.
Remove electrical tape from electrical wires and thread
one wire through each hole in the weatherproof
hanging ball cover and then thread the safety cable
through the same hole as the ground wire as shown.
Pull weatherproof hanging ball cover down securely
over hanging ball (on downrod).
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
A
safety cable
green/ground
wire
downrod
canopy
cover
page 4
set screw hole
stop pin
hanging ball
B
weatherproof
hanging ball
cover
electrical
wiring
hanging ball
canopy
yoke cover
motor
housing