Automated Learning Process./ Activating Code; Important - stori Epilogue Guia De Instalacion

10. Automated Learning Process./
Activating Code.
CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is
remote control
transmitter
not desired, turn wall switch off to any other
(backside)
programmable receiver or fan.
Remove battery cover from backside of remote
control transmitter.
battery
Install one 3-volt battery (size CR2032, included)
in transmitter. Replace battery cover on
transmitter.
IMPORTANT: To prevent damage to remote
battery
control transmitter, remove the battery if not
cover
used for long periods. Store the transmitter
away from excess heat or humidity.
WARNING: Choking Hazard - Small parts. Keep
battery away from children.
WARNING: To avoid personal injury, DO NOT
charge or heat battery. DO NOT break battery
apart or cause battery to become deformed.
WARNING: BATTERY DISPOSAL INFORMATION,
Place insulating tape around battery before fan button
disposing of the battery. Do not dispose of this
battery along with other lithium batteries nor
place beside other metal objects in the trash.
Failure to follow these guidelines may cause the
battery to burst or catch fire.
Restore electrical power. Within 30 seconds of
restoring electrical power, press the "Off"
transmitter
button ( ), located on the front of the
(front)
transmitter, for 5 seconds (or fan blades begin
to turn). Test the fan functions to confirm the
learning process is complete--see Section 12.
page 7