Canopy Assembly; Blade Assembly; Final Fan Assembly - stori Epilogue Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened screw
in hanging bracket and push up. Twist canopy to
lock. Re-insert screw that was removed and then
tighten both screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it stops.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.

8. Blade Assembly.

Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 12 blade attachment screws and washers
in hardware pack. Observe label on blade
indicating THIS SIDE UP and then slide blade
through one of the narrow, rectangular openings
on motor housing. Make sure to align holes in
blade with holes in blade arm, which is located
on the INSIDE of the motor housing and can be
seen from the UNDERSIDE of the motor
housing--refer to drawing at right. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat procedure for
each remaining blade.
NOTE: Tighten blade attachment screws twice a
year.

9. Final Fan Assembly.

Remove 1 screw from motor plate (on
underside of motor) and partially loosen the
other 2 screws. Align slotted holes in fitter plate
with loosened screws in motor plate. Twist fitter
plate to lock. Re-insert screw that was just
removed and tighten all 3 screws securely.
Place metal cover over fitter plate, aligning hole
in center of metal cover with threaded rod in
fitter plate. Tighten metal cover securely.
screw
canopy
canopy cover
blade arm
(inside motor
housing)
fitter plate
threaded
rod
page 6
antenna
hanging bracket
screw
motor housing
blade
blade attachment
screws and washers
motor
housing
motor plate
metal cover