BGS technic 865 Manual De Instrucciones página 6

Press the adhesive pad accurately and quickly to the surface of
the dent area.
Do not press too hard, so that the adhesive should form a thick
layer between the adhesive pad and dent area.
T-Bar Hammer
When glue and connector adhesive pad is set, slide the T-bar
hammer slowly and steadily until the dented area restored.
Use to clean and dissolve a standard 90% acetone-water
solution.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed