Ingersoll Rand RX-264H Manual De Utilización Y Mantenimiento página 15

Figure 2 RX-344H Stop Switch
2. Open the FUEL COCK ( , [Figure 3]) located under the
fuel tank.
RX-344H only: Move the FUEL VALVE LEVER to the "ON"
position [Figure 4].
Figure 3 Fuel Cock
CLOSE
Figure 4 RX-344H Fuel Valve Lever
3. Close the CHOKE LEVER.
RX-264H: [Figure 5]
RX-344H: [Figure 6]
If the engine is cold or the ambient temperature is low, close
the Choke Lever fully. If the engine is warm or the ambient
temperature is high, open the Choke Lever half-way, or keep
it fully open.
STOP SWITCH
ON
CLOSE
OPEN
FUEL VALVE
LEVER
ON
Figure 5 RX-264H Choke Lever
CLOSE
Figure 6 RX-344H Choke Lever
CHOKE LEVER
CLOSE
4. Position the THROTTLE LEVER [Figure 8] to "LOW" speed
position.
5. Pull the STARTER HANDLE ( , [Figure 7]) of RECOIL
STARTER slowly until resistance is felt. This is the
"COMPRESSION" point. Return the Handle to its original
position and pull swiftly. After starting the engine, allow the
Starter Handle to return to its original position while still
holding the Handle.
Figure 7
After the engine starts, set the Throttle Lever [Figure 8] at the
low speed position "LOW" and warm it up without load for a few
minutes. Fully open CHOKE LEVER ( , [Figure 5] [Figure 6])
gradually.
7-EN
CHOKE LEVER
OPEN
OPEN
RX-264H/RX-344H Upright Rammer
Operation & Maintenance Manual
EN