Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
489469-00 BDL500 laser
with the hanging cone attached to the back and then hanging the unit on the nail or screw.
Make sure it is straight and seated firmly on the cone and that the unit is secure on the wall.
DANGER: Laser Radiation, avoid direct eye exposure.
HELPFUL HINTS
• If the laser light becomes dim or is no longer visible when the switch is in the on position
check or change the batteries.
• The laser lines are only level on the wall against which the unit is held or hung. The short
line visible on any adjacent wall is not level.
• The unit can be used on a floor during locked laser mode.
• The laser unit is equipped with a pendulum lock that stops pendulum motion when the
laser on/off switch is moved to the off position.
• If the laser on/off switch is pushed part way to the on position, the laser lines may be on
while the pendulum lock is still engaged.
• When using unit over a stucco wall, place a piece of cardboard over the surface to help
provide a smooth motion across the wall.
STORAGE
Always store the laser indoors in its protective case.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement
parts.
T T
T T
Problem
• Laser does not project
on wall.
• Laser projects on wall
but lines are not level.
8/18/05
10:51 AM
Page 7
R R
O O
U U
B B
L L
E E
S S
H H
O O
R R
O O
U U
B B
L L
E E
S S
H H
O O
Possible Cause
• Weak battery.
• The self leveling range
of the unit is +/-5
degrees, if the unit is not
held within 5 degrees of
vertical, the laser lines
will not project on wall.
• Wall on which the unit is
mounted or held must be
within +/- 5 degrees of
vertical for the self
leveling mechanism to
function correctly. If this
is exceeded, the lines will
still project but may not
be level.
• The laser on/off switch
must be pushed to the
full on position.
7
O O
T T
I I
N N
G G
O O
T T
I I
N N
G G
Solution
• Replace with fresh battery.
• Be sure that the unit is as
straight up and down as
possible.
• Use the unit against vertical
walls only, lines will not be
level on sloped walls or other
non-vertical surfaces.
• Be sure laser on/off switch is
in the full on position.
Publicidad
Tabla de contenido
