Safety Instructions; Fcc Warning - Black and Decker BDL500S Manual De Instrucciones

489469-00 BDL500 laser
WARNING: Read and understand all
instructions. Failure to follow all
instructions listed below may result in
electric shock, fire and/or serious
personal injury.
SAVE THESE INSTRUCTIONS

Safety Instructions

DANGER: Laser Radiation, avoid
direct eye exposure, serious eye injury
can result.
• Do not use optical tools such as a
telescope or transit to view the laser
beam.
• Position the laser so unintentional eye
contact will be avoided.
• Do not operate the laser around children
or allow children to operate the
laser.
• Do not disassemble. Modifying the
product in any way can increase the risk
of laser radiation.
WARNING: Use of controls or
adjustments or performance of
procedures other than those specified in
this manual may result in hazardous laser
radiation exposure.
• Do not operate in explosive atmospheres,
such as in the presence of flammable
liquids, gases, or dust.
• Use only with the specifically designated
batteries. Use of any other batteries may
create a risk of fire.
• Store idle product out of reach of children
and other untrained persons. Lasers are
dangerous in the hands of untrained
users.
• Use only accessories that are
recommended by the manufacturer for
your model. Accessories that may be
suitable for one laser, may create a risk of
injury when used on another laser.
• Repairs and servicing MUST be
performed by a qualified repair facility.
Repairs performed by unqualified
personnel could result in serious injury.
• Do not remove or deface warning labels.
Removing labels increases the risk of
exposure to radiation.
• For indoor use only.
• This product is intended for use in a
temperature range of 41°F(5°C) -
104°F(40°C).
WARNING: SHOCK HAZARD. Use
caution when drilling, nailing or cutting
into walls, floors and ceilings which may
contain electrical wiring or pipes. Always
turn off the power when working near
electrical wires.
8/18/05 10:49 AM Page 2
Liquid Crystal Display (First Aid
Measures)
• If liquid crystal comes in contact with your
skin:
Wash area off completely with plenty of
water. Remove contaminated clothing.
• If liquid crystal gets into your eye:
Flush the affected eye with clean water
and then seek medical attention.
• If liquid crystal is swallowed:
Flush your mouth thoroughly with water.
Drink large quantities of water and induce
vomiting. Then seek medical attention.
The label on your tool may include the
following symbols.
V ................................volts
mW ............................milliwatts
nm..............................wavelength in
..................................nanometers
IIIa..............................Class IIIa Laser
For your convenience and safety, the
following labels are on your laser.
AVOID EXPOSURE. LASER RADIATION
IS EMITTED FROM THESE APERTURES.

FCC WARNING:

This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any
interference received, including
interference that may cause
undesirable operation.
2
AVOID EXPOSURE. LASER RADIATION
IS EMITTED FROM THESE APERTURES.
DANGER PELIGRO
LASER RADIATION. AVOID DIRECT EYE EXPOSURE.
RADIACIÓN LÁSER. EVITE LA EXPOSICIÓN DIRECTA DE LOS OJOS.
MAXIMUM OUTPUT POWER< 5mW@633nm-670nm CLASS IIIa LASER PRODUCT. THIS PRODUCT
COMPLIES WITH THE APPLICABLE REQUIREMENTS OF 21CFR PARTS 1040.10 AND 1040.11.
LÁSER CLASE IIIa CON MÁXIMA POTENCIA DE SALIDA < 5mW@633nm-670nm. ESTE PRODUCTO
CUMPLE CON LOS REQUISITOS APLICABLES DE LAS PIEZAS 1040.10 Y 1040.11 DE 21CFR.