Trouble Shooting - HOLZMANN MASCHINEN PSM2 Manual De Instrucciones

¡ERROR! UTILICE LA PESTAÑA INICIO PARA APLICAR ÜBERSCHRIFT 1 AL TEXTO QUE DESEA QUE
13

TROUBLE SHOOTING

BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Machine will not start
Poor polishing performance
Scratches on the work
surface
Poor dust extraction
Burns on the working
surface
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you
have not the prescribed training for it always attract a workshop to fix
the problem.
HOLZMANN MASCHINEN GmbH
Possible cause
 Switch defective
 Power supply is off
 Fuse is defectivet
 Electric contactor is defective
 Unauthorized or worn abrasive
 Insufficient pressure of drum
 Insufficient V-belt tension
 Worn V-belt
 Wrong abrasive
 Drum surface dirty or damaged
 Dust bag for more than 1/3 filled
 Dust bag dirty
 Worn or fine abrasive
 Too high drum pressure
www.holzmann-maschinen.at
Solution
 Repair switch
 Repair power supply
 Change fuse
 Repair or change electric
 Change abrasive
 Increase drum pressure
 Tighten V-belt
 Change V-belt
 Change abrasive
 Clean or change drum
 Empty dust bag
 Wash the dust bag
 Change abrasive
 reduce drum pressure
NOTICE
APAREZCA AQUÍ.
contactor
PSM 2 / PSM 3
27