Black+Decker MTIM3 Manual Del Usuario página 5

This tool is not intended for use by persons
u
(including children) with reduced physical,
sensory or mental capabilities, or lack of expe-
rience and knowledge, unless they have been
given supervision or instruction concerning use
of the appliance by a person responsible for
their safety. Children should be supervised to
ensure that they do not play with the appliance.
The intended use is described in this instruc-
u
tion manual. The use of any accessory or
attachment or performance of any operation
with this tool other than those recommended
in this instruction manual may present a risk of
@ personal injury and/or damage to property.
Warning! mpact wrenches are not
torque wrenches. Do not use this tool
for tightening fasteners to specified
torques. An independent, calibrated
torque measurement device such
as a torque wrench should be used
when under tightened or over tight-
ened fasteners can lead to the failure
of the joint.
(Original instructions)
Features (fig. A)
Tool shown is MT143. Other tools are available for
use with this tool head.
This tool includes some or all of the following
features.
10. Chuck
11. Chuck collar
Assembly
Warning! Before assembly, remove the battery
from the tool.
Fitting and removing a screwdriver bit or
socket (fig. B)
This tool is fitted with a quick release chuck to
allow for an easy exchange of bits.
Warning! Make certain the tool is locked to pre-
vent switch actuation before installing or removing
accessories.
Lock the tool by setting the forward/reverse
u
slider (2) to the centre position.
Pull and hold the chuck collar (11) away from
u
the front of the tool.
Insert the bit shaft (12) into the chuck (10).
u
Release the collar. The accessory is locked in
u
place.
Note! To remove the bit/socket repeat the above
steps.
ENGLISH
5