WALL SET INSTALLATION (Continued)
5. Prepare for Plumbing Fixtures
Y
◘
Measure and mark location for plumbing fixtures on back
of side panel.
CAUTION:
Drill chuck can damage panel. Drill holes from
back side of side panel.
◘
Using proper size hole saw, cut out plumbing fixture holes
from back side of panel.
7. Dry Fit Side Panels
Hook
Slot
◘
Position each side panel, pushing the hooks into back
panel slots.
◘
Push down firmly until panel tops are even.
Y
X
Backside of
back panel
Backside of
side panel
6. Apply Fire Retardant Pad
Drill holes
from back.
Backside
of panel
X
◘
Remove backing from self-adhesive pad.
◘
Center pad over mixing valve hole and press firmly onto
back side of panel.
◘
Using a utility knife, trim pad to reveal mixing valve hole.
8. Prepare Side Panels
Top flange
Flanges
CAUTION:
Do not drill 3/16" holes directly into studs. Drill chuck can
damage panel. Use an extended bit holder to reduce risk of
drill chuck hitting panels.
◘
Drill 3/16" holes at all stud locations on top flanges.
◘
Drill 3/16" holes along side flanges at 5 locations equal
distance apart.
5
Mixing valve hole
Drill 3/16" clearance holes into fl anges only.
Self-adhesive pad
Top
flange
Side
flange
P/N 27748 8/10