PEERLESS Selva Manual De Instrucciones página 6

Ocultar thumbs Ver también para Selva:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WALL SET INSTALLATION (Continued)
9. Mark Panel Height
Top flange
Check that flanges on panels are straight and square to
bathtub.
Using a pencil, mark panel height on all wall studs.
11. Secure Back Panel
Top flange
1-1/4" screws
(panhead or roundhead)
Press back panel in place.
IMPORTANT!
Gaps between fl anges and studs must be
less than 1/8". Insert shims to fi ll gaps.
Secure top flanges to studs with 1-1/4" screws.
 CAUTION:
Use panhead or roundhead screws. Do not
overtighten screws, this can cause panel to crack.
Less than
Shim
1/8" gap
10. Apply Adhesive and Sealant
Top
flange
Side
flange
Remove and disassemble panels.
TIP: Pressure may be required to disengage hooks from
slots.
 APPLY ADHESIVE
 APPLY SEALANT
12. Apply Adhesive and Sealant
 APPLY SEALANT
shown.
 APPLY ADHESIVE
6
Back panel
support
to back panel support.
along back of bathtub.
along side of bathtub and back panel as
to studs.
P/N 27748 8/10
Pencil line

Publicidad

Tabla de contenido
loading

Tabla de contenido