Converting From Blower To Vacuum - Remington BV12199A Manual Del Propietário

Converting from
Blower to Vacuum
WARNING: To Reduce The
Risk of Personal Injury or Electric
Shock – Disconnect from power
source before assembling or
changing attachments.
Follow the steps below to convert from
blower to vacuum. IMPORTANT: You must
install the collection bag/adapter before
installing the vacuum tube assembly. The
vacuum tube assembly hooks into the
collection bag/adapter. The vacuum will
not run unless the vacuum tube assembly
is locked into place.
1. Press locking lever on bottom inlet
cover and remove bottom inlet cover
from blower/vac. Remove blower tube
from blower/vac.
2. Slide vacuum tube adapter onto outlet
on front of blower/vac housing (see
Figure 3-5). Make sure the adapter
locks into place.
118034
Figure 3-5: Sliding vacuum tube adapter into place
REMINGTON® ELECTRIC BLOWER/VAC | 5