Converting From Blower To Vacuum - Remington RM191BV Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Converting from
Blower to Vacuum
WARNING: To Reduce The
Risk of Personal Injury or Electric
Shock – Disconnect from power
source before assembling or
changing attachments.
Follow the steps below to convert from
blower to vacuum. IMPORTANT: The
vacuum will not run unless the vacuum
tube assembly is locked into place.
1. Press locking lever on bottom inlet
cover and remove bottom inlet cover
from blower/vac. Remove blower tube
from blower/vac.
2. Slide vacuum tube adapter onto outlet
on front of blower/vac housing (see
Figure 3-6). Securely connect the
draw latch to the vacuum bag adapter
(see Figure 3-7).
3. Connect the lower and upper vacuum
tubes together (see Figure 3-8). Align
the ridge on the bottom tube with
the channel on the top tube. Press
together until you hear a "snap".
Figure 3-6: Sliding vacuum tube adapter into place
Figure 3-7: Connect draw latch to vacuum bag adapter
Remington electRic bloweR/vac |
Figure 3-8: Conntecting lower and upper vacuum tube
together
5
1

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rm193bvt

Tabla de contenido