Operating Modes; Exhaust Air Mode; Circulating-Air Mode; Operating The Appliance - Siemens iQ700 LC98KA271 Instrucciones De Uso

Operating modes

This appliance can be used in exhaust-air mode or circulating-
air mode.

Exhaust air mode

The air which is drawn in is cleaned by the
grease filters and conveyed to the exterior
by a pipe system.
Note: The exhaust air must not be conveyed into a functioning
smoke or exhaust gas flue or into a shaft which is used to
ventilate installation rooms which contain heat-producing
appliances.
Before conveying the exhaust air into a non-functioning
■
smoke or exhaust gas flue, obtain the consent of the heating
engineer responsible.
If the exhaust air is conveyed through the outer wall, a
■
telescopic wall box should be used.

Operating the appliance

These instructions apply to several appliance variants. It is
possible that individual features are described which do not
apply to your appliance.
Note: Switch on the extractor hood when you start cooking and
switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Control panel
Explanation
1 Switch the fan on/off
2 Switch on the lighting
3 Turn the fan down
4 Display panel
5 Switch up the fan setting
6 Switch on intensive mode
7 Switch on fan run-on

Circulating-air mode

The air which is drawn in is cleaned by the
grease filters and an activated carbon filter and
conveyed back into the kitchen.
Note: To bind odours in circulating-air mode, you must install
an activated carbon filter. The different options for operating the
appliance in circulating-air mode can be found in the brochure.
Alternatively, ask your dealer. The required accessories are
available from specialist outlets, from customer service or from
the Online Shop. The accessory numbers can be found at the
end of the instructions for use.

Setting the fan

Note: Always adjust the fan strength to meet current conditions.
If there is a large build-up of steam or fumes, select a high fan
setting.
Switching on the appliance
Press the button.
#
1.
The fan starts at setting 1.
Press the "+" or "-" buttons to set another fan setting.
2.
Switching off the appliance
Press the 0 button.

Intensive setting

You can use the intensive setting if there is a large build-up of
odours and fumes/vapours.
Press the › button while ventilation is switched on.
1.
The intensive setting is activated.
Press the › button.
2.
The intensive setting is deactivated.
Note: The intensive setting run time is 6 minutes. Once this
time has elapsed, the appliance switches back to the fan
setting that was previously set.

Fan run-on time

Press the x button.
1.
The fan continues to run at this fan setting for 15 minutes and
then switches off automatically after this time. The current fan
setting and the remaining run-on time in minutes are
displayed alternately in the display panel. If the lighting is
switched on, this is also switched off after the run-on time.
Press the x button again.
2.
The fan run-on ends before the end of the remaining run-on
time.
13