Removing Metal Grease Filter; Cleaning The Metal Mesh Grease Filters; Installing The Metal Mesh Grease Filter; Changing The Activated Charcoal Filter (Only In Circulating-Air Mode) - Siemens iQ700 LC98KA271 Instrucciones De Uso

Removing metal grease filter

Fold the filter cover upwards.
1.
Notes
The opening angle of the filter cover is restricted to approx.
■
80°. Do not open the filter cover any further, otherwise the
hinges may be damaged.
The filter cover locks in any position.
■
Remove the two metal grease filters under the filter cover and
2.
the metal grease filter on the underside of the appliance.
Unfasten the lock, fold the metal filter forwards and remove it
from the bracket.
Note: Grease can accumulate at the bottom of the metal
grease filter. Hold the metal grease filter level, otherwise
grease will drip out.
Clean the metal grease filter.
3.
After removing the filters, clean the inside of the appliance.
4.
Clean the filter cover.
5.

Cleaning the metal mesh grease filters

These instructions apply to several appliance variants. It is
possible that individual features are described which do not
apply to your appliance.
:
Risk of fire!
Grease deposits in the grease filter may catch fire.
Clean the grease filter at least every 2 months.
Never operate the appliance without the grease filter.
Notes
Do not use any aggressive, acidic or alkaline cleaning
■
agents.
When cleaning the metal mesh grease filters, also clean the
■
holder for the metal mesh grease filters in the appliance
using a damp cloth.
The metal mesh grease filters can be cleaned in the
■
dishwasher or by hand.
By hand:
Note: You can use a special grease solvent for stubborn dirt. It
can be ordered via the Online Shop.
Soak the metal mesh grease filters in a hot soapy solution.
■
Clean the filters with a brush and then rinse them thoroughly.
■
Leave the metal mesh grease filters to drain.
■
In the dishwasher:
Note: If the metal mesh grease filters are cleaned in the
dishwasher, slight discolouration may occur. This has no effect
on the function of the metal mesh grease filters.
Do not clean heavily soiled metal mesh grease filters together
■
with utensils.
Place the metal mesh grease filters loosely in the dishwasher.
■
The metal mesh grease filters must not be wedged in.

Installing the metal mesh grease filter

Insert the two metal grease filters under the filter cover with
1.
the lock facing downwards.
Insert the metal grease filters on the underside of the
appliance.
Fold the metal grease filters inwards, locking them in place.
2.
Close the filter cover.
3.
Press and hold the "-" button for two seconds.
4.
The saturation display is reset.
Changing the activated charcoal filter (only in
circulating-air mode)
In order to guarantee efficient odour filtration, the filter must be
serviced regularly.
The activated charcoal filters must be replaced at least every
4 months.
Notes
The activated charcoal filters are not included in the delivery.
■
The activated charcoal filters can be obtained from specialist
retailers, from our after-sales service or from the Online Shop.
The activated charcoal filters cannot be cleaned or
■
reactivated.
For removing the metal grease filter, see above.
1.
Turn the old activated charcoal filter and pull away from the
2.
bracket. ¨
Push the new activated charcoal filter onto the bracket and
3.
turn.
©
For fitting the metal grease filter, see above.
4.
Press and hold the "-" button for two seconds.
5.
The saturation display is reset.
15