Porcher L'Expression II 97520 Instrucciones De Instalación Cuidado Y Mantenimiento página 4

INSTRUCTIONS TO INSTALL TOILET SEAT
12a
Insert rubber gaskets into seat holes
12d
Thread the attachment nuts onto the
mounting screws. Tighten the screws
with a screwdriver.
13
LIFT ARM
FIRST
IMPORTANT: Always
clear sand and rust from
system.
• Make sure water supply
is off. Remove valve TOP
by lifting arm and rotating
top and arm 1/8 turn
counterclockwise, pressing
down slightly on cap.
GUARANTEE: This Fluidmaster product is guaranteed to be free from defective materials and
workmanship for a period of one year. Units returned to Fluidmaster will be replaced without charge.
Always use quality Fluidmaster repair parts when maintaining your Fluidmaster products. Fluidmaster
shall not be responsible or liable for any damages caused by products used with Fluidmaster valves
that were not manufactured by Fluidmaster, Inc.
12b
Place seat on bowl. Be careful to center
hinges with the rubber gaskets.
12e
Snap the two hinge covers into place.
• While holding a • Replace TOP by engaging
container over the lugs and rotating 1/8 turn
uncapped VALVE to clockwise. MAKE CERTAIN
prevent splashing, turn TIP IS TURNED TO THE
water supply on and off a
LOCKED POSITION.
few times. Leave water VALVE MAY NOT TURN
supply off.
ON IF TOP IS NOT FULLY
TURNED TO THE LOCKED
POSITION.
12c
12f
IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK
SLOWLY, repeat Step 13.
IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF
NON-USE, it is a signal you are wasting water because:
• The end of the refill tube is inserted into overflow pipe, below
water level in tank. Attach refill tube to overflow pipe using clip
provided.
• The flush valve is leaking because it's worn or dirty. Replace
flush valve assembly as needed.
IF FILL VALVE WON'T TURN ON OR SHUT OFF or REFILL
OF TANK WATER IS SLOW after valve has been in use for
some time, Fluidmaster Model 242 Replacement Seal may be
needed.
Go to our website at www.fluidmaster.com for more
solutions to toilet problems.
For troubleshooting information please contact:
4
Insert the two mounting screws
through the hinges.
TOILET SEAT CARE AND CLEANING
When cleaning your toilet seat wash it
with mild, soapy water: rinse the seat
thoroughly with clear water: and dry
with a soft cloth.
Avoid detergents, disinfectants, or
cleaning products in aerosol cans.
NEVER use abrasive scouring powders
on your seat. Some bathroom
chemicals and cosmetics may damage
the seat's finish. After installation,
check the tightness of the bolts from
time to time to ensure a tight fit.
TROUBLESHOOTING
30800 Rancho Viejo Road
San Juan Capistrano, CA 92675
(949) 728-2000 (800) 631-2011
www.fluidmaster.com
© 2001 Fluidmaster, Inc.
® Registered trademark of Fluidmaster, Inc.
7 30 1 1 9 6 - 1 0 0 R e v. A