Uline H-8939 Guia De Inicio Rapido

H-8939
FIRE RATED FLOOR SAFE
TOOLS NEEDED
Drill Phillips Screwdriver
HARDWARE INCLUDED
70 mm Lag Screw x 2
IMPORTANT! Record the serial number from the
tag on back of safe.
Keep keys and combination in a secure place,
away from children.
Do not store backup key, combination or this
document in the safe.
WARNING! Keep safe closed and locked at
all times when not in use. Children could
accidentally be locked inside the safe.
Do not move this safe using its handle. The
handle should only be used for opening and
closing the door of the safe.
Do not store electronic media, computer disks,
audio-visual media or photographic negatives
in this safe. This material will not survive the
rated internal temperature of the safe. This
material may be damaged or destroyed.
BATTERY INSTALLATION
User must first install the battery. When battery is low and
button is pressed on keypad, a red light will come on
warning that battery is low.
NOTE: When changing the battery, always
hold the battery connecting cap while
disconnecting or attaching the battery. Do not
pull on the wires. Doing this could cause the
power supply to become disconnected from
the lock.
PAGE 1 OF 9
17 mm Socket Wrench
Washer x 2 40 mm Plastic Anchor x 2
1-800-295-5510
uline.com
7/16" Drill Bit
USAGE
1. To replace battery, remove cover by pressing the
tab and turning cover. (See Figure 1)
2. Replace old battery and turn cover back in place.
Use one 9V alkaline battery.
ELECTRONIC LOCK
1. After installing battery, to open an electronic lock
the first time, press the following numbers/symbols
on electronic keypad in this order: 1-5-9-#. These
numbers are preset.
NOTE: Change entry code as soon as possible
after opening the safe to ensure proper
security.
2. After entering factory code, turn handle clockwise
to open door. User will have five seconds to turn the
handle before locking mechanism is reactivated.
Figure 1
1120 IH-8939