Uline H-8937 Guia De Inicio Rapido

H-8937
DIGITAL SAFE
TOOLS NEEDED
Drill Flathead Screwdriver
HARDWARE INCLUDED
50 mm Lag Screw x 4
IMPORTANT! Record the serial number from the
tag on back of safe.
Keep keys and combination in a secure place,
away from children.
Do not store backup key, combination or this
document in the safe.
GETTING STARTED
1. When first receiving the safe, open door with key in
order to install batteries. Batteries are included and
are located inside the safe.
2. To open door with key, first remove lock cover from
front of faceplate using a flathead screwdriver, as
shown. Insert key and turn counterclockwise. Hold key
in open position and turn knob to the right to open
door.
NOTE: Turn the key clockwise before removing
to reengage the locking mechanism.
NOTE: Key has also been provided in case
security code is lost or forgotten or if batteries
run low. If key is lost, reference serial number
located on the back of the safe to get a
replacement.
PAGE 1 OF 6
1-800-295-5510
uline.com
10 mm Socket Wrench
Washer x 4 40 mm Plastic Anchor x 4
Lock Cover
3/8" Drill Bit
USAGE
3. Locate batteries inside the safe. Open battery
compartment on back of door by pushing tab to the
left. Install batteries.
ENTERING SECURITY CODE
1. After installing batteries, locate reset button on
inside of door near hinge.
2. Press reset button and release it; user will hear
a beep. DO NOT SHUT DOOR UNTIL USER HAS
CONFIRMED NEW SECURITY CODE HAS BEEN ENTERED
CORRECTLY.
3. With door open, enter user's personal security code,
which can be three to eight digits long, and confirm
new code by pressing the check mark key
electronic touch pad. User will have five seconds to
press the check mark key
have to start over from step one. There will be two
beeps (if sound is turned on) and green light will
flash twice if code has been entered successfully.
Before closing door, enter new security code. Press
the check mark key
knob so that it can turn and retract the live-action
locking bolts.
4. If code fails, go through steps 1-3 again. If code
works successfully, then lock safe.
5. When opening the safe in the future, enter security
code set, followed by the check mark key
turn knob.
, otherwise user will
to make sure lock releases
, and
0621 IH-8937
on