Uline H-6731 Instrucciones De Instalación

H-6731
FIRE RATED
STANDARD SAFE
TOOLS NEEDED
Drill Flathead Screwdriver
HARDWARE INCLUDED
50 mm Lag Washer x 4
Screw x 4
GETTING STARTED
1. When you first receive the safe, open the door with
the key in order to install the batteries. Batteries are
included, located inside the safe.
2. To open door, first remove lock cover from front of
faceplate using a flathead screwdriver, as shown
below. Insert key and turn counterclockwise. Hold
key in the open position and turn knob to the right to
open the door.
NOTE: This key has also been provided in case
you lose or forget your security code or if the
batteries run low. If you lose the key, you'll
need to reference the serial number located
under the removable lock cover to get a
replacement. Contact Uline Customer Service
for additional assistance.
3. Locate batteries inside safe. Open battery
compartment on the back of the door by pushing
the tab. Install the batteries.
PAGE 1 OF 9
1-800-295-5510
uline.com
10 mm Wrench 3/8" Drill Bit
40 mm Plastic
Anchor x 4
USAGE
Lock Cover
3/16" Drill Bit
NOTE: The reset button located on the inside
of the door is covered with a removable cap.
When you use the reset button while setting
combination, remove cap to access button.
Use a pen tip to push the reset button. Replace
the cap securely over the reset button after
setting combination. Failure to do so will
compromise the safety and security of the safe.
ENTERING SECURITY CODE
To enter security code, follow the steps listed below:
1. After installing the batteries, locate the reset button
on the back of the door.
2. Press the reset button with a pen tip and release it;
you will hear a beep. DO NOT SHUT THE DOOR UNTIL
YOU HAVE CONFIRMED THAT YOUR NEW SECURITY
CODE HAS BEEN ENTERED CORRECTLY.
3. With the door open, enter security code, which can
be three to eight digits long, and confirm code by
pressing the key on the electronic touch pad.
You will have three seconds to press the
otherwise you will have to start over from step one.
There will be two beeps (if the sound is turned on)
and the green light will flash twice if code has been
entered successfully. Before closing door, enter the
new security code. Press the
the lock releases the knob so that you can turn it
and retract the live-action locking bolts.
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
key,
key to make sure
0721 IH-6731