DeWalt DXGST227BC Manuel Del Operador página 14

INSTALLING AND ADJUSTING THE HANDLE
Installing the Handle
1. Place the handle between the top clamp and middle clamp (Fig. 4). If necessary, rotate or flip the
middle clamp until the holes in the top clamp and middle clamp align.
2. Place the clamps and handle over the upper shaft housing and onto the bottom clamp (Fig. 4).
NOTE: Make sure the curved portion of the handle is on the operator's left (Fig. 4).
3. While holding the pieces together, insert the bolts (x4) into the aligned holes (Fig. 4).
4. Screw a nut onto the end of a bolt, but only slightly. Push the nut into the hexagonal recess on the
bottom clamp. Hold the nut in place with a finger to keep it in the recess. Tighten the bolt with a
Phillips screwdriver, but do not tighten it completely (Fig. 4). Repeat this step for each nut and bolt.
5. Hold the unit in the operating position (Fig. 13) and slide the handle in or out of the clamp until the
arrow/line on the decal touches the clamp (Fig. 5).
6. Angle the handle forward or backward, as desired.
7. Tighten the bolts with a Phillips screwdriver until the handle is secure.
Adjusting the Handle
If the handle requires adjustment:
1. Loosen the bolts (x4) slightly with a Phillips screwdriver (Fig. 4).
2. Hold the unit in the operating position (Fig. 13) and angle the handle forward or backward, as desired.
3. Tighten the bolts with a Phillips screwdriver until the handle is secure.
Primary Hole
Release Button
Guide Recess
Fig. 3
14