Mini chopper quantities and processing times (HR1615 only)
Ingredients
Chopping
quantity
Onions & eggs
100g
Meat
120g (max)
Herbs
20g
Parmesan cheese
50-100g (max)
Nuts and almonds
100g
Garlic
50g
Extra-large chopper quantities and processing times
(HR1617 only)
Ingredients
Chopping
quantity
Onions and eggs
200g
Meat
200g
Herbs
30g
Nuts and almonds
200g
Dry bread
80g
Parmesan cheese
200g
Dark chocolate
100g
Put the lid on the chopper bowl (Fig. 6).
3
Fasten the motor unit onto the chopper lid ('click') (Fig. 7).
4
Put the plug in the wall socket.
5
Press the on/off button or the turbo speed button to switch on the
6
appliance.
Note: If the ingredients stick to the wall of the chopper bowl, loosen them with
a spatula or by adding liquid.
Note: Do not process more than 1 batch without interruption. Let the appliance
cool down for 5 minutes before you continue processing.
Whisk (HR1617 only)
The whisk is intended for whipping cream, whisking egg whites, desserts etc.
Connect the whisk to the coupling unit ('click') (Fig. 8).
1
Connect the coupling unit to the motor unit ('click') (Fig. 9).
2
Put the ingredients in a bowl.
3
See the table for the recommended quantities and processing times.
Whisking quantities and processing times (HR1617 only)
Ingredients
Whisking quantity
Cream
250ml
Egg whites
4 eggs
Tip: When you beat egg whites, use a large bowl for the best result.
Tip: When you whip cream, use the beaker to avoid splashing.
Tip: To prevent splashing, start at a low speed setting and continue with a higher
speed after approx. 1 minute.
Note: Do not process more than 1 batch without interruption. Let the appliance
cool down for 5 minutes before you continue processing.
Put the plug in the wall socket and press the on/off button.
4
After approx. 1 minute, you can press the turbo button to continue at
5
turbo speed.
Cleaning (Fig. 10)
Do not immerse the motor unit, the whisk coupling unit (HR1617
only), the mini chopper lid (HR1615 only) and the extra-large chopper lid
(HR1617 only) in water.
Unplug the appliance.
1
Press the release buttons on the motor unit to remove the accessory
2
you have used.
Disassemble the accessory.
3
3
Time
Speed
5 x 1sec.
1-4
5sec.
turbo
5 x 1sec.
8-12
15sec.
turbo
20sec.
turbo
5 x 1sec.
turbo
Time
Speed
5 x 1sec.
1-4
10sec.
turbo
10 x 1sec.
8-12
30sec.
turbo
30sec.
turbo
20sec.
turbo
20sec.
turbo
Time
70-90sec.
120sec.
Tip: You can also remove the rubber rings from the chopper bowls for extra
thorough cleaning.
See the separate cleaning table at the end of this user manual for
4
further instructions.
Tip: For quick cleaning, pour warm water with some washing-up liquid in the
beaker, insert the blender bar and let the appliance operate for approx. 10
seconds.
Storage
You can store the motor unit, the blender bar and the whisk (HR1617
1
only) in the beaker (Fig. 11).
Environment
-
Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an official collection point for
recycling. By doing this you help to preserve the environment (Fig. 12).
Accessories
You can order a direct-driven mini chopper (under service code number
4203 035 83450) from your Philips dealer or a Philips service centre as an
extra accessory for the HR1617, HR1615 and the HR1614.
Use the quantities and processing times of the mini chopper for this
accessory.
Guarantee and service
If you need service or information or if you have a problem, please visit
the Philips website at www.philips.com or contact the Philips Consumer
Care Centre in your country (you find its phone number in the worldwide
guarantee leaflet). If there is no Consumer Care Centre in your country, go
to your local Philips dealer.
4222.005.0115.1