Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ABOUT THE CODES
CL
– Your CONTROLS ARE LOCKED on the current setting. Activate the control lock by holding the power button for five
seconds, until CL appears. Your Table-Top will lock on the current fan and humidity settings. Release the lock by pressing the
power button again for five seconds until the display flashes CL three times, letting you know the lock is off.
CF
– The CF code triggers after 720 hours of use and means it's time to CHECK YOUR FILTER (wick). Unplug your unit and
check your wick. If your wick is still in good shape, simply clear the code by plugging your humidifier back in. If your wick
needs replacing, follow these quick steps:
1.
Remove the water bottle from the base.
2.
Remove the old wick and replace it with a new SGL1040 Super Wick®.
3.
Reassemble the unit.
6
Press the fan button again to select
your desired fan speed. Your Table-Top
has four fan speeds that are displayed by F1 (the
lowest speed) through F4 (the highest speed). F0
indicates your Table-Top is in standby mode.
7
Press the humidity control button
to set your humidity level from 25% to
65%. The humidistat on your cord will read your
home's humidity and turn your fan off when the
set level is reached. When set to 65%, your unit
will run continuously.
That's it! Your Table-Top is ready to use.
HOW TO CLEAN YOUR TABLE-TOP
Regular cleaning is important for preventing mold,
mildew, and other bacterial growth in your humidifier.
It also keeps your Table-Top working its best.
1. Let the unit run until it's empty, then turn it off and
unplug it.
2. Remove the water bottle and the wick. Throw your
wick away if it is time to replace it. Otherwise, put it in a
sink while you finish cleaning your Table-Top.
3. Pour out any remaining water from the base and bottle.
4. Fill the bottle half-full with water and add 1/2 cup of
white vinegar. Put the cap back on, shake the bottle
gently, then let sit for 20 minutes. To disinfect, replace
the vinegar with 1 teaspoon of bleach. Do not mix
vinegar and bleach.
5. After 20 minutes, empty the bottle.
6. Dampen a sponge with white vinegar and wipe down
the base, water bottle, and cap. Rinse everything
thoroughly. To disinfect, replace the vinegar with
bleach.
7. Wipe everything dry and replace the wick, if needed.
Then reassemble.
When storing your Table-Top, discard the used wicks and disinfect
the unit using the directions above. Dry the unit thoroughly, and
store in a temperature-regulated area. Do not install new wicks until
you are ready to use your humidifier again.
6
Publicidad
Tabla de contenido
