Date And Time - yellow jacket 52030F Instrucciones De Operación

5. Press the SET button to confirm.
6. Press the back button to exit the current menu.
Note: High temperature alarm and low temperature alarm can be enabled
simultaneously or separately.
SETTINGS
To enter the Settings menu:
1. Press the SET button to open the main menu.
2. Press the left/right button to select the Setting symbol option.
3. Press the SET button to confirm.
TO SET THE LANGUAGE FOR THE THERMAL IMAGER
1. Press the up/down button to select the Language option in the Settings
menu.
2. Press the SET button to enter the Language submenu.
3. Press the up/down button to select the desired language. Choose from
English or Chinese.
4. Press the SET button to confirm.
5. Press the back button to exit the current menu.

DATE AND TIME

TO SET THE DATE & TIME
EMISSIVITY/TEMPERATURE COMPENSATION
Emissivity is a number which describes a materials ability to emit thermal
radiation. It is a number between 0.1 and 1. A number like 0.1 represents
a perfect reflector (like aluminum foil) whereas the number 1 represents a
perfect emitter (like black cloth). You can adjust the emissivity setting of
the thermal imager to match the material being measured. Using an emis-
sivity setting that matches the material you are measuring will ensure that
your temperature measurements are as accurate as possible. For example,
if you are monitoring the temperature of concrete as it cures, you would set
emissivity to 0.94 (see chart below) so your measurement is as accurate as
possible.
TO SET EMISSIVITY
1. Press the up/down button to select the
2. Press the SET button to enter the
1. Press the up/down button to select the
Date & Time option in the Settings
menu.
2. Press the SET button to enter the Date &
Time submenu.
3. Press the left/right button to select the
parameter to be adjusted.
4. Press the SET button.
5. Press the up/down button to increase
or decrease the value.
6. Press the SET button to save the
settings and return to set other
parameters.
7. Press the back button to exit the current
menu.
Emissivity option in the Settings menu.