Ergomotion Motion Air El Manual Del Propietario página 11

installation guide installation guide installation guide
STEP 5
Locate the Head Motor (GREEN) . Align the holes in the white bushings
with the holes on the frame .
Slide a Pin through a washer, then through the holes of the Head Motor .
Secure the Pin with another washer and a Clip (Fig .E3) .
Fig.E1 Fig.E2
Pin Washer
STEP 6
a . Remove the Pin from the Head Motor
Bracket so that you may install the
Head Motor .
b . Insert a washer into each side hole of
the Head Motor Bracket .
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
Fig.E3
Washer Clip
Fig.F1
Fig.F2
c . Align the holes of the Head Motor with
the holes of the Head Motor Bracket .
d . Slide a Pin through the washers and
holes in the Head Motor, then secure it
with a Clip .
STEP 7
Head assembly is now complete .
All three green labels should be on the
same side.
STEP 8
a . Locate the Foot Motor Bracket
(YELLOW) . Slide the bracket into place
over the bolt on the frame shown in
Fig .H1, and align the "F" holes with the
corresponding head bracket holes on
the base (Fig .H2) .
Fig.F3
Fig.F4
Fig.G1
Fig.H1
9