Thermal Cut-Out; Safety Switch; Cleaning - Silvercrest SHLF 2000 A1 Instrucciones De Servicio

RP89886 Heizlüfter mit LCD und FB LB5 Seite 46 Donnerstag, 23. Mai 2013 6:32 18
2. To switch the swivel function off, press
the swivel function button 17 or 21
again.

6.8 Thermal cut-out

For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, the appliance switches
off automatically:
1. Switch the mains switch 8 to 0 to switch
off the appliance.
2. Check whether the air inlet or outlet is
obstructed and remove the cause.
If you cannot establish a cause and the
fault occurs repeatedly, have the
appliance repaired or else take it out of
use.
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning! To avoid the danger of
an electric shock or burning:
– remove the mains plug before
each clean;
– allow the appliance to cool
down;
– never immerse the appliance in
water;
– never allow water or cleaning
agent to run into the appliance.
1. Carefully remove major dust deposits
from the protective guards with a
vacuum cleaner.
2. Remove any remaining dirt with a soft
brush.
46
3. Wait for the appliance to cool down.
4. You can then continue to operate it
normally.

6.9 Safety switch

The appliance
accidental damage by a safety switch.
The safety switch is
located on the bottom
of the appliance and
switches the appliance
off immediately should
it fall over:
1. Return the appliance to an upright
position.
2. Select the required function again (see
"6.1 Displays" on page 44).

7. Cleaning

Take care not to let any dust fall inside
the appliance. You should therefore hold
the appliance so that the protective
guard you are in the process of cleaning
is facing downwards.
3. Clean the outside of the appliance with
a damp cloth. You could also use a little
washing-up liquid.
Caution! Never use caustic or abrasive
cleaning agents, as this could damage
your appliance.
4. Wipe the appliance with a cloth
moistened with clear water.
5. Do not use the appliance again until it
has dried completely.
is protected against