Remote Control Operation; Testing Your Fan - Craftmade Cronus Guia De Instalacion

9. Remote Control Operation.

button - Tap once to turn LIGHT ON or OFF.
Liquid crystal display shows the amount of
brightness as a percentage.
button - cycles through 3 FAN SPEEDS
and then returns to the OFF setting.
IMPORTANT: Store the transmitter away from
excess heat or humidity. To prevent damage
to transmitter, remove the battery if
transmitter will not be used for long periods.

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and light switch (if applicable).
Test fan speeds with the
the remote control. Test the light ON/OFF
function with the button on the remote
control. (For more detailed information on
using remote control, see Section 9 above.)
If the remote control operates all of the
functions of the fan and light, battery has
been installed correctly. If fan and/or light
do (does) not function, please refer to
"Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the
reverse switch, located on top of motor
housing (diagram 1). Set reverse switch to
recirculate air depending on the season:
- LEFT position in summer
(diagram 2)
- RIGHT position in winter
(diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower
your thermostat setting in winter without
feeling a difference in your comfort.
Important: Reverse switch must be set
either completely to the LEFT or completely
to the RIGHT for fan to function. If the
reverse switch is set in the middle position
(diagram 4), fan will not operate.
button on
page 10
light setting
light button
fan button
diagram 1
diagram 2
diagram 3
fan setting
motor
housing
reverse switch
diagram 4