Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
11. Automated Learning Process./Activating Code.
CAUTION: The wall and/or handheld remote control can be programmed to
multiple receivers or fans. If this is not desired, turn wall switch off to any other
programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on
wall control to the ON position. Within 60 seconds of turning on the wall
control, press and hold the OFF button on the wall control for 5 seconds
(or until light blinks twice or fan blades begin to turn).
Turn power off again for at least 5 seconds and then turn power back on.
Within 60 seconds of restoring the power, press and hold the OFF button
on the front of the handheld remote control for 5 seconds (or until light
blinks twice or fan blades begin to turn).
Test the light and fan functions to confirm the learning process is
complete--see Section 13 below.
12. Remote Control Operation.
ON/OFF slider switch - turns wall control ON or OFF
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L1 button - turns light kit ON/OFF when pressed once;
dims light kit when pressed and held down
L2 button - (not applicable for this fan)
REV button - used to REVERSE blade direction
(fan must be set on low before reversing blade
direction)
13. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test wall control (optional
installation) by locating ON/OFF slider switch on wall
control, then set to the ON position. Test light and
dimmer function and then test fan speeds. Next, locate
handheld remote control. Test the light ON/OFF function
by pressing the L1 button; test the dimmer function by
pressing and holding the L1 button for up to 5 seconds.
Test fan speeds with the different fan speed buttons. If
the wall and/or handheld remote control operates all of
the functions of the fan, battery (batteries) has/have been
installed correctly. If the wall and/or handheld remote
control do (does) not operate all of the fan/light functions,
refer to "Troubleshooting" section to solve any issues
before contacting Customer Service.
Fan must be on LOW before setting the fan to reverse
direction. Use the REV button to recirculate air depending
on the season.
NOTE: If the wall control/handheld remote control
interferes with other appliances, turn power off first and
then go back to the instructions in Section 11 above.
(switch not functional on handheld remote)
page 10
-
1 1
-
2 2
handheld
wall control
remote control
-
1 1
-
2 2
Publicidad
Capítulos
Tabla de contenido
