Canopy Assembly; Light Kit Assembly; Important - Craftmade Cronus Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the
open end of the hanging bracket.
Partially loosen the other screw. Lift
canopy to hanging bracket. Place
rounded part of slotted hole in canopy
over loosened screw in hanging bracket
and push up. Twist canopy to lock.
Re-insert screw that was removed and
then tighten both screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy
cover with screwheads in bottom of
canopy. Turn canopy cover to the right
(clockwise) until it stops.

8. Light Kit Assembly.

Install 2 medium base 9 watt LED bulbs
(included).
Locate slots on glass shade and align
with nodules on fitter plate (located on
underside of motor housing).
push up on glass shade and turn
RIGHT (clockwise) until it slides
completely into place.
IMPORTANT: When you need to replace
bulbs, please allow bulbs and glass shade
to cool down before touching.
Gently
to the
page 9
receiver
canopy cover
bulb
antenna
hanging
bracket
canopy
screw
nodule
fitter plate
bulb
glass shade