Automated Learning Process./Activating Code; Remote Control Operation; Testing Your Fan - Craftmade TMP52BNK5 Guia De Instalacion

11. Automated Learning Process./Activating Code.

CAUTION: The wall and/or handheld remote control can be programmed to
multiple receivers or fans. If this is not desired, turn wall switch off to any other
programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on
wall control to the ON position. Within 60 seconds of turning on the wall
control, press and hold the fan OFF button on the wall control for 5 seconds
(or until light blinks twice or fan blades begin to turn).
Turn power off again for at least 5 seconds and then turn power back on.
Within 60 seconds of restoring the power, press and hold the OFF button on
the front of the handheld remote control for 5 seconds (or until light blinks
twice or fan blades begin to turn).
Test the light and fan functions to confirm the learning process is complete--
see Section 13 below.

12. Remote Control Operation.

ON/OFF slider switch - turns wall control ON or OFF
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L1 button - turns uplight ON/OFF when pressed once;
dims uplight when pressed and held down
L2 button - turns light kit ON/OFF when pressed once;
dims light kit when pressed and held down
REV button - used to REVERSE blade direction
(fan must be set on low before reversing blade
direction)

13. Testing Your Fan.

It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable).
Test wall control (optional installation) by locating ON/OFF slider
switch on wall control, then set to the ON position. Test ON/OFF
and dimmer function on light kit (L2) and uplight (L1) and then
test fan speeds. Next, locate handheld remote control. Test the
light ON/OFF function by pressing the L2 and then the L1 button.
Test the dimmer function by pressing and holding down the L2
button for 1 second; repeat with the L1 button. Test fan speeds
with the different fan speed buttons. If the wall and/or handheld
remote control operates all of the functions of the fan and light,
battery has been installed correctly. If the wall and/or handheld
remote control do (does) not operate all of the fan/light
functions, refer to "Troubleshooting" section to solve any issues
before contacting Customer Service.
Fan must be on LOW before setting the fan to reverse direction.
Use "reverse" button to recirculate air depending on the season.
NOTE: If the wall control/handheld remote control interferes with
other appliances, turn off power and go back to the instructions
in Section 11 above.
(switch not functional on handheld remote)
page 9
- 1 1
-
2 2
wall control
remote control
- 1 1
- 2 2
handheld