Front Panel Status Indicators - Watts IntelliFlow A2C-SC Instrucciones De Instalación

Front Panel Status Indicators

GREEN LED: ON: Unit powered
YELLOW LED: ON: Water supply open
OFF: Water supply closed
Sensor Plug
RED LED: ON: Leak sensed
BLINKING: Unit timed out
FAINT BLINK: (3-5 seconds)
User Button
What is Surge Protection?
In many locations, changes in the AC volt-
age supply to the home by the electrical
utility company can occur. Both lower-volt-
age (brownouts) and high-voltage (surges)
can occur. Lightning strikes can also cause
high-voltage spikes to occur.
All electronic equipment is designed to
operate properly within a voltage range.
However, high-voltage surges or spikes can
damage sensitive circuitry within electronic
equipment.
Surge protectors prevent voltage spikes
from reaching electronic equipment.
IS-A2C-SC-IntelliFlow 2102
This lamp is illuminated whenever the IntelliFlow is plugged
into a powered wall outlet.
This lamp is illuminated whenever the IntelliFlow senses
current flow (the washing machine is turned on). It is off
when the washing machine is turned off.
NOTICE
Some washing machine models include circuitry that causes
a slight current draw at all times. These models when con-
nected to the IntelliFlow can cause the water supply to be
energized continuously (YELLOW LED: ON).
This lamp is illuminated when the leak sensor is installed
and water has been detected at the sensor. The water sup-
ply to the washing machine hoses are interrupted when a
leak is detected.
This lamp blinks whenever the internal timing circuit has
timed out and has shut off the water supply to the washing
machine hoses. Turning the washing machine Off then On
will reset the timing circuit.
This condition indicates the leak sensor is unplugged. To
provide the maximum level of protection, it is recommended
that the leak sensor be installed at all times.
Press for 3 seconds to turn WiFi on or off.
Press for 10 seconds to factory reset the IntelliFlow and
erase all user information.
What is Ground Fault
Protection?
In many locations, an electrical differential
between an electrical ground and a water
pipe ground can exist. A person touching
both grounds could receive a shock that
may cause injury or death. A ground fault
interrupter circuit (GFI) detects the differential
and removes electrical power before injury
can occur.
The IntelliFlow does not cause or change
the electrical differential that exists.
13
© 2021 Watts