Installing The A2C-Sc Intelliflow - Watts IntelliFlow A2C-SC Instrucciones De Instalación

Installing the A2C-SC IntelliFlow

WARNING
!
Power MUST be off during installation or servicing of the valve!
Do not plug valve into supply circuit until completion of assembly.
NOTICE
1. Shut off electrical power supply to the electrical receptacle to be used with the IntelliFlow.
2. Shut off both hot and cold water supply lines.
3. If retrofitting to an existing installation, disconnect the washing machine hoses from the
existing shutoff valve(s).
4. Loosen the two (2) adapter nuts and remove both adapters from IntelliFlow valve body.
5. Place adapter nuts over piping prior to soldering adapters.
6. Solder adapters onto piping.
NOTICE
Piping must be 2 ⁄
3
8
7. Place O-rings on adapter grooves (Figure 3A).
8. Align and slip the valve body over adapters. Tighten adapter nuts.
NOTICE
Use of the IntelliFlow
other than a washing machine is not recommended and voids the warranty.
6
IS-A2C-SC-IntelliFlow
For Vertical Installation Only!
" on center (Figure 3).
O-Ring
Washing Machine Smart Water Shutoff outlet for appliances
®
2102
®
2 ⁄ "
1
2
Figure 3
Adapter Nut
Adapter
Water Supply Piping
Figure 3A
© 2021 Watts