Kohler K-2271 Guia De Instalacion página 3

Note: When determining cut-out location, allow for adequate
clearance between the backsplash and the lavatory.
K-2271
1. Preparation
Install the water supplies and drain piping according to the
roughing-in information.
Determine which template cut line corresponds with the lavatory
model to be installed.
Cut out the template where indicated for countertop opening. Cut
along the inside of the cutting line.
Position the template on the countertop.
NOTE: Be sure to provide sufficient spout overhang into the
lavatory basin. See the roughing-in notes for minimum spout length
information.
Check for adequate clearance between the backsplash and
lavatory.
Refer to the wall-mount faucet installation instructions for
required clearance, and mark the preferred faucet hole locations
using a soft lead pencil.
Trace the template on the countertop with a pencil.
Kohler Co.
Backsplash
Outside Edge
of Lavatory
Cut-out Line
K-2273
3 1018899-2-A