Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

1. BEFORE YOU BEGIN
NOTES
S
Use these instructions for wall-mount, self-rimming,
and above-counter installations. Follow only the
instructions that apply to your installation.
S
This lavatory gives the consumer the opportunity to
be creative and flexible with the installation.
S
The consumer can choose between a wall-mount or
countertop faucet installation, depending upon the
setting and styling they desire. A wall-mount faucet
is recommended.
S
These instructions contain important care, cleaning,
and warranty information – please leave these
instructions for the consumer.
S
Prior to installation, unpack the new lavatory, and
carefully inspect it for damage. Return the lavatory
to its protective carton until ready to install it.
TOOLS AND MATERIALS REQUIRED
S
Safety glasses
S
Safety shoes
S
Pencil
S
Scissors
S
Tape Measure
2. INSTALLATION
WALL-MOUNT BRACKET INSTALLATIONS:
Turnings and Conical Bell Vessels lavatories can be
installed on this wall-mount bracket. The Hex Strata is not
suitable for wall-mount bracket installation.
Refer to the roughing-in information included with your
lavatory to correctly locate the water supply lines and
drain outlet.
Install the lavatory according to the instructions packed
with the bracket.
A
1007250-2-
R
VITREOUS CHINA LAVATORIES
Español, Página 5
Français, Page 9
ABOVE-THE-COUNTER
PRODUCT INFORMATION
Turnings 76 Lavatory
Conical Bell Lavatory
Hex Srata Lavatory
. . . . . . . . . . . . . . . . . . . . .
Waters Grove
Lavatory
Garden Bandana
Lavatory
S
Hole Saw
S
Keyhole saw or saber saw
S
Drill (1/2" dia. drill bit, or larger)
S
Screwdriver
Fig. #1
VESSELS
. . . . . . . . . . . . . . . . . . .
K-2191
. . . . . . . . . . . . . . . . . . .
K-2200
K-2203
. . . . . . . . . . . . . . .
K-14222
. . . . . . . . . . . .
K-14223
E2001 Kohler Co.

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Kohler VESSELS Turnings 76

  • Página 1 Refer to the roughing-in information included with your lavatory to correctly locate the water supply lines and drain outlet. Install the lavatory according to the instructions packed with the bracket. Fig. #1 Español, Página 5 E2001 Kohler Co. 1007250-2- Français, Page 9...
  • Página 2 Install the custom linkage as shown. Adjust and/or bend the linkage as required to achieve smooth, effective Lift Rod pop-up drain operation. Only bend the linkage at the location shown at right. Fig. #4 Kohler Co., Kohler, WI, U.S.A. 1007250-2-...
  • Página 3 Follow the instructions listed on the sealant label. Allow the sealant to set for 30 minutes or more. Connect the drain and faucet supply fittings. Fig. #5 Turn on the water supplies, and check for leakage. Kohler Co., Kohler, WI, U.S.A. 1007250-2-...
  • Página 4 First review the installation instructions to ensure correct installation. For additional assistance in the USA, call our Customer Service Department for direct help. You may also contact us at our web site listed below. Call 1-800-4-KOHLER within the U.S. Call 001-877-680-1310 within Mexico Call 1-800-964-5590 within Canada www.kohlerco.com...
  • Página 5: Vessels Sobre El Mostrador Lavabos De Loza Vítrea

    Consulte el diagrama de instalación incluida con el lavabo, para localizar correctamente las líneas de suministro y de desagüe. Instale el lavabo según las instrucciones incluidas. Fig. #1 Kohler Co., Kohler, WI, U.S.A. 1007250-2-...
  • Página 6 Instale la articulación como se ilustra. Ajuste y/o doble la articulación como sea necesario, para lograr la operación Varilla de suave y eficaz del drenaje levantable. Doble la levante articulación sólo en el lugar ilustrado a la derecha. Fig. #4 Kohler Co., Kohler, WI, U.S.A. 1007250-2-...
  • Página 7 Permita que el sellador seque, al menos por 30 minutos o más. Conecte las líneas de suministro del grifo y drenaje. Fig. #5 Abra los suministros de agua, y verifique que no haya fugas. Kohler Co., Kohler, WI, U.S.A. 1007250-2-...
  • Página 8: Para Asistencia

    Primero, revise las instrucciones para asegurarse de haber realizado la instalación correcta. Si no logra solucionar el problema, llame al Departamento de Atención al Cliente para obtener asistencia directa. También puede localizarnos en la página web escrita abajo. Llame al 1-800-4-KOHLER (En los Estados Unidos) Llame al 001-877-680-1310 (En México) Llame al 1-800-964-5590 (En Canadá) www.kohlerco.com...
  • Página 9: Avant De Commencer

    Hex Strata en utilisant ce support au mur. Reportez-vous au diagramme de raccordement qui accompagne le lavabo, pour déterminer l’emplacement correcte des tuyaux d’alimentation et d’évacuation. Installez le lavabo selon la notice d’installation du Fig. #1 fabricant. Kohler Co., Kohler, WI, U.S.A. 1007250-2-...
  • Página 10 Installez la tringle réglable tel qu’illustré. Ajustez et pliez la tringle tel que nécessaire pour permettre un fonctionnement mécanique aisé correct Tige de levage l’évacuation. Pliez la tringle seulement au point désigné ci-contre. Fig. #4 Kohler Co., Kohler, WI, U.S.A. 1007250-2-...
  • Página 11 Laissez prendre le mastic pour au moins Fig. #5 30 minutes. Raccordez le tuyau d’évacuation au renvoi et les tubes d’arrivée d’eau au robinet. Ouvrez le robinet et vérifiez s’il y a des fuites. Kohler Co., Kohler, WI, U.S.A. 1007250-2-...
  • Página 12: Renseignements Importants

    Revoir d’abord la notice d’installation pour s’assurer d’une installation correcte. Pour toute assistance additionnelle, contactez notre département de service à la clientèle. Vous pouvez aussi nous joindre sur notre site Web à l’adresse donnée ci-dessous. Aux É.-U., composer le 1-800-4-KOHLER Au Mexique, composer le 001-877-680-1310 Au Canada, composer le 1-800-964-5590 www.kohlerco.com...

Tabla de contenido