Changing The Color Settings - Commercial Electric 74208/HD Guía De Uso Y Cuidado

Changing the Color Settings

4-way color changing:
1. You can lock in one color temperature, change
among multiple color temperatures, dim from 10%-
100%, memorize the last color temperature and reset
automatically.
2. Light Switch Marks on the lamp represent: SW
(Soft White) - BW (Bright White) - DL (Daylight) - Switch
(Light Switch)
3. When the slide switch is set to SW (Soft White), the
color temperature is set at 3000K.
4. When the slide switch is set to BW (Bright White), the
color temperature is set at 4000K.
5. When the slide switch is set to DL (Daylight), the color
temperature is set at 5000K.
6. When the slide switch is set to SWITCH, the color
temperature can be changed from SW-BW-DL with your
existing light switch.
To change color temperatures using your
existing light switch:
A. Set the slide switch on the back of the fixture to SWITCH.
B. Toggle your light switch ON and OFF within 0.5-3 sec-
onds to cycle though the three different color temperatures.
C. If the fixture is left On for over 10 seconds then turned
OFF, the fixture will remember the last color temperature
selected and will display that color when turned on again.
D. The reset function is used when using multiple Color
Selectable lighting products operating from the same light
switch. In the event that multiple fixtures are not displaying
the same color at the same time, the fixtures must be RE-
SET using your existing light switch. Simply toggle the wall
switch ON and OFF five times, leaving it in the ON position
for 5 second intervals. (ex: With the fixture in the ON posi-
tion, toggle the wall switch OFF then ON, leaving it ON for
5 seconds, then OFF then ON, leaving it ON for 5 seconds.
(Repeat five times.)
NOTICE: The toggle switch is located on the back of the fixture.
WARNING: CHANGES OR MODIFICATIONS NOT
EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE
FOR COMPLIANCE COULD VOID THE USER'S AUTHORITY
TO OPERATE THE EQUIPMENT.
WARNING: RISK OF FIRE OR ELECTRIC SHOCK.
INSTALLATION OF THIS RETROFIT ASSEMBLY REQUIRES
A PERSON FAMILIAR WITH THE CONSTRUCTION AND
OPERATION OF THE LUMINAIRE'S ELECTRICAL SYSTEM
AND THE HAZARD INVOLVED. IF NOT QUALIFIED, DO
NOT ATTEMPT INSTALLATION. CONTACT A QUALIFIED
PERSON.
WARNING: RISK OF FIRE OR ELECTRIC SHOCK. INSTALL
THIS KIT ONLY IN THE LUMINAIRES THAT HAS THE
CONSTRUCTION FEATURES AND DIMENSIONS SHOWN
IN THE PHOTOGRAPHS AND/OR DRAWINGS AND WHERE
THE INPUT RATING OF THE RETROFIT KIT DOES NOT
EXCEED THE INPUT RATING OF THE LUMINAIRE.
DO NOT MAKE OR ALTER ANY OPEN HOLES IN AN
ENCLOSURE OF WIRING OR ELECTRICAL COMPONENTS
DURING KIT INSTALLATION.
WARNING: TO PREVENT WIRING DAMAGE OR ABRASION,
DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR
OTHER SHARP OBJECTS.
THIS DEVICE IS NOT INTENDED FOR USE WITH
EMERGENCY EXITS OR NOT FOR EMERGENCY LIGHTING.
Center Beam
3 ft
5 ft
8 ft
15 ft
7
Please contact 1-877-527-0313 for further assistance.
LIGHTING DISTRIBUTION
Beam Diameter
(Foot Candles)
22 9.2 ft
8
15 ft
3.1
24 ft
0.9 46 ft
Beam Angle = 114º
HOMEDEPOT.COM