Technical Specifications - HK Audio SONAR 115 Sub D Manual De Instrucciones

Settings:
MODE Normal
X-OVER SONAR (or set the frequency to match other speakers)
Further settings as required
• Full-stack System with Cardioid Subwoofers
(two subwoofers per side)
SONAR 115 Sub D comes with two presets, Cardioid Front and Cardioid Rear,
that provide a fast, easy way of confi guring eff ective cardioid setups.
Note: For a cardioid setups to work properly, the two subwoofers must be
stacked on top of each other. The top subwoofer (sub #1) has to face the
audience (Front); the bottom subwoofer (sub #2) has to face the stage
(Rear). A side-by-side array will not achieve the desired eff ect! Also, be
sure to always maintain a distance of at least one meter from walls.
#1
#2
Side view
Signal fl ow:
External mixer Out L/R
2x SONAR Sub #2 Thru (L or R each)
2x SONAR Sub #1 Thru (L or R each)
Settings:
MODE Sub #1: "Cardioid Front"
Sub #2: "Cardioid Rear"
Set both subwoofers to the same volume level
Note: In "Cardioid Front" and "Cardioid Rear" operating modes, the menu
items Bass Boost, Polarity, X-Over and Delay are locked and cannot be
changed by the user (see "2.2 Menu items / Mode").
Good to know: While speakers are able to throw midrange and high
frequencies in directional patterns, low frequencies tend to radiate in all
directions. Excessive bass levels can often be a problem on and behind the
stage. These days, demands for limiting low-range frequencies' throw range
to clean up the on-stage sound with cardioid subwoofer confi gurations.
What is a cardioid setup? Put simply, it's a bass rig where one or more
subwoofer(s) points towards the audience and the other subwoofer(s)
face(s) the stage. With some phase rotation and delays, this setup
delivers practically undiminished bass response to the front while heavily
attenuating the amount of bass thrown to the rear. This cleans up the on-
stage sound.
Good to know: Set the rearward-facing subwoofer's Display Dim option to
On if the light is distracting. This temporary setting is lost when the unit
powers down. You'll have to set this option again every time you power the
unit up.
4 Optional HK Audio Accessories
The variety of accessories may diff er from time and region. Please visit the
SONAR product page at www.hkaudio.com to learn more.
2x SONAR Sub #2 In (L or R each)
2x SONAR Sub #1 In (L or R each)
2x SONAR Xi Line In
5 Technical Specifi cations
Modell SONAR 115 Sub D
Max. SPL @ 10% THD 125 dB half space
Max. SPL peak 128 dB half space
Frequency response +/- 3 dB 40 Hz – X-over
Frequency response -10 dB 36 Hz – X-over
Power amp output (peak power) 1500 W
Amp type Class D
Active protective circuits Subsonic Filter, Thermo Protection, Overload Protection; Peak,
RMS Limiter
Bass woofer 1x 15", 3" voice coil
Active x-over frequency 60 – 150 Hz, variable
Display 2.2" LCD
Audio ports in 2x XLR Combo In bal.
Audio ports out 2x XLR Thru bal.
Setup modes Cardioid Front, Cardioid Rear, SONAR
DSP functions Bass Boost, Polarity, X-Over, Delay, Front LED, Display Dim, Reset
Delay up to 10 m
Power consumption 0.8 A / 220-240 V AC • 1.6 A / 100-120 V AC
Nominal according to EN 62368-1
Pole mount 1x M20
Grips 2x MultiGrip
Housing Wood
Finish Black acrylic enamel
Front grille Metal grille backed with black acoustic foam
Dimensions (WxHxD) 43 x 61.2 x 61.6 cm • 16-15/16 x 24-61/64 x 24-17/64"
Weight 28.4 kg / 62.6 lbs
FCC STATEMENT
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator
& your body.
IC WARNING
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada's licence-exempt RSS(s). Operation is subject
to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. Lexploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne diot pas produire de brouillage, et
(2) l'utilisateur de lappareil diot accepter tout bouillage radioélectrique subi, méme si le brouillage est
susceptible d'en compromettre le fonctionnement.
SONAR 115 Sub D 1.1
7