Main Functions; Changing Settings - Autoclima Fresco 5000 Back Instrucciones Para El Uso

5.1 - MAIN FUNCTIONS

- A rapid pressure on the button turns
ON – OFF
When the device is on, the display always shows the last set
- Every pressure of the key cycles through the modes MIN, AUTO and MAX. The corresponding icon lights up.
MIN
MODE
AUTO
MAX
- When the device is off, if you press the MODE button, you will activate the DEFERRED ACTIVATION mode and the relative icon
display; the number of hours can be set between 1 and 99 by using the TEMPERATURE
Each
VENTILATION
-
of ventilation. The display will show the selected level.
- When the device is off, if you press the (+ / -) button, you will activate only the ventilation.
TEMPERATURE - Each pressure of the (+ / -) buttons corresponds to the increase or decrease of one degree of temperature: from a minimum value
of 17 to a maximum of 32. The display will show the selected temperature.

5.2 - CHANGING SETTINGS

WARNING: before changing any setting, carefully read the following notes.
WARNING: changing the standard settings must be carried out only by qualified personnel. Any change performed without the proper skills
may cause damage to "FRESCO 5000 BACK" and/or to the vehicle.
To access the setting menu, simultaneously press the
20
This corresponds the lowest power setting of "FRESCO 5000 BACK" (lowest performance and lowest compressor
speed – the timer is set for a continued function of 6 hours, after which "FRESCO 5000 BACK" goes off
automatically). (The timer can be modified with the
The management is automatic (performance and compressor speed are managed automatically based on the
temperature required by the user and on the current temperature - the timer is set for a continued function of 4 hours,
after which "FRESCO 5000 BACK"
the "Changing the settings"
This corresponds to the highest power setting of "FRESCO 5000 BACK" (highest performance and highest
compressor and ventilator speed), after 20 minutes "FRESCO 5000 BACK" goes to the "AUTO" mode.
lights up: "FRESCO 5000 BACK" will turn itself on automatically after a certain number of hours have elapsed, shown on the
pressure (+ / -) corresponds to the increase or decrease of the ventilation speed: you can choose between 6 different levels
IT IT EN FR DE ES EN FR DE ES
"FRESCO 5000 BACK". on and off.
temperature.
P0 parameter - see the "Changing the settings" section).
goes off automatically).
section).
(+ / -) and (+) buttons while the device is off.
MAX
AUTO
MIN
MODE
(The timer can be modified with the
(+ / -) buttons..
P1 parameter - see