Du Pont QuickTwist WFQTR13000 Serie Guia De Inicio Rapido página 5

STEP 5
Install the QuickTwist
1 B
Hold the QuickTwist ® Filter with the label facing to the left slightly. The two nozzles on top of the QuickTwist
toward the back of the QuickTwist
1
out to each side. See Figure 5
2
Lift the QuickTwist ® Filter straight up into the System Head
on top of the QuickTwist ® Filter are fully engaged into the System Head.
3
®
Turn the QuickTwist Filter left to right until it stops.
STEP 6
Test the Filter System for Proper Operation
1
Turn on the cold water shut-off valve to your refrigerator
2
Flush the Filter for approximately 10 minutes by allowing the water to run through the filter without it being connected to the
refrigerator or ice cubes may be cloudy with carbon fines. Use a bucket to catch flushed water. If your refrigerator doesn't have a
water dispenser - remove the 1/4 tubing from the outlet and let the water run into a bucket for 10 minutes to flush the system.
3
Check for any leaks between the System Head Assembly and Filter and tubing connections.
If there are leaks between the System Head Assembly and the QuickTwist
Turn off the cold water shut-off valve to the Filter System and run the cold water tap to drain the water and
n
release pressure.
Remove the QuickTwist ® Filter and inspect the O-Rings around the nozzles on top of it. Make sure they are in place and free
n
from dirt and particles.
Replace the QuickTwist ® Filter by lifting it straight up into the System Head until the two nozzles seat into the ports and the
n
two extended flanges on top of the QuickTwist
left to right until it stops.
Turn the cold water supply valve back on and turn on the Faucet for Filtered Water.
n
If there are leaks around the fittings:
Turn off the cold water shut-off valve to the Filter System to release pressure in the System.
n
While pulling the 1/4" Plastic Tubing
n
to make sure that the 1/4" Plastic Tubing is cut squarely and that it is not scratched. If the 1/4" Plastic Tubing is unevenly cut
or scratched, cut off 1/2" to 5/8" and re-install the Plastic Tubing (see Step 5 of Installation Instructions).
Turn the cold water shut-off valve back on and turn on the Faucet for Filtered Water.
n
If leaks continue, turn off the water supply and call Customer Service.
4
If all is work properly, turn the icemaker back on.
WFQTR130004
® Filter
® Filter. If holding properly, the two extended flanges on top of the QuickTwist
at right.
A
until the two nozzles seat into the ports and the two extended flanges
® Filter are fully engaged into the System Head. Turn the QuickTwist
L
with one hand, press in on the grey collar around the inlet and/or outlet fitting. Check
® Filter should be
® Filter should be
® Filter:
5
5
1
2
3
® Filter
A
B
V4.1C