universalblue UVT1323-21 Manual De Instrucciones página 32

Note: Fastening screws (included) are designed for use with the
fan and are fastened to wooden beams or concrete ceiling. If
the installation is carried out on a different material, it is advisable to
use the appropriate fixing screws for that material (these screws are not
supplied with this equipment).
STEP BY STEP
Note:
The images are for guidance only and should be used to support the
installation.
1. Install the blades on the fan head using the screws
provided (fig. 1).
2. Join the components of the rod in order shown in the
picture (fig. 2).
3. Move the electric cable through the inside of the rod
towards the other side (fig. 3).
4. Assemble the rod with the fan head (fig. 4.)
5. Adjust the fastening screw through the rod and the top of
the fan head. (fig. 4).
6. Lock the screw position with the fork. (fig. 6).
7. Set the rod position by screwing it in (fig, 7).
8. Place the fixing stick at the top end of the rod (fig. 8).
9. Slide the rod down as shown in the picture (fig. 9)
10. Disassemble the cable holder to split them. (fig.10 and
11).
11. Using a drill, make the holes in the ceiling according to the
dimensions of the fan screw holes (fig. 12).
12. Note the diffrents installation between a wooden and a
concrete ceiling (fig. 13).
13. Disconnect general electricity current (fig. 14).
14. Connect the wiring in their respective positions (fig. 15)
(phase:brown, neutral: blue, ground: green)
15. Attach the rod to the ceiling support and turn it until you
hear a "click" sound (fig. 17).
16. Add the remote control receiver to the base of the ceiling
(fig. 18).
32